Simply put, it tricks the car into burning less fuel when it’s cruising under a light load ... Arduino. The video does a wonderful job going into the details, but essentially by using an oxygen ...

IMPORTANT: Remember to go to the "Sketch" tab and upload the sketch to load the credentials ... that shows how to use Arduino Cloud with webhooks to save sensor data in online spreadsheets.

It wasn’t hard to put an LED strip on a broom and light it up based on a load sensor reading, but what ended up sinking this project was the need to do it in a way that didn’t interfere with ...

The Arduino allows you to mix and match sensors with hardware to interact ... A USB 2.0 connector is used to load code and can provide enough power to run the unit. You can also monitor serial ...

By simply choosing a wireless sensor gateway for one’s favorite development platform (Arduino, Raspberry Pi or BeagleBone Black) and any of over 20 different types of wireless sensors ...

By counting the pulses from the output of the sensor, we can easily calculate the water flow rate (in litre/hour – L/hr) using a suitable conversion formula. The Arduino Sketch (code) uses the ...

The Pressure Sensor Module incorporates a material called Velostat with the Arduino. This material adds more resistance when more pressure is applied to the material. This module also uses the RGB LED ...

The hardware is consists of an Arduino microcontroller (here an Arduino Uno R3) and a pre-wired soil moisture sensor module. The soil moisture sensor module , built around the LM393 comparator, gives ...

The MEAS weather shield with five environmental sensors on an Arduino/Genuino 101- and Uno R3-compatible board from TE Connectivity is available from Mouser Electronics. The five sensors are: the TE ...