The BC26S is the cable designed as the terminal-to-printer cable or null modem cable for use on the VT278. The cable features two female 90° 25-position D-subminiature connectors on both ends, which allows the cable to fit inside the cable cover on the back of the VT278.

General The VT100 video terminal is a data transaction terminal supporting a wide variety of user-controllable character and screen attributes. Additional features include smooth scrolling, selectable column widths and typewriter-like detachable keyboard. The following describes VT100 supplies and accessories. Supplies.

This sounds stupid, but did you make sure that your serial to USB cable is also a null-modem cable? I've had the same issue, until I figured out that I had to get a small null-modem bridge in order to actually communicate with a server with a serial console.

Sep 21, 2015 · To connect to the BIG-IP system using the serial port, you must have a DB9 null modem cable and a VT100-capable terminal emulator available on the management system. To configure a serial terminal console for the BIG-IP system, perform the following procedure:

EIA RS-423 specifies a maximum cable length of 61 m (200 ft). VT102 User Guide. Describes the installation, operation, and programming of the VT102. This document is shipped with the terminal. VT101 Series Pocket Service Guide. Describes procedures used to troubleshoot and repair the VT102 to the field replaceable unit.

Oct 23, 2021 · At my desk, I use the on-board DB9 serial cable, with a DB9 to DB9 null-modem cable, and a DB9 to DB25 adapter connected to my DEC terminal. They also make DB9 to DB25 null modem cables, if you don't want to have a separate adapter.

Aug 1, 2015 · To assign a static IP Address, access the switch from the serial console port as follows: 1. Connect a console to the switch. Using the null-modem cable supplied with the switch, connect a VT100/ANSI terminal or a workstation to the switch port labeled Console. 2. Start a terminal emulation program (TEP). a.

Oct 9, 2021 · So I bought a VT100 with the intention of hooking it up directly to my linux based virtualization server. Looking in the manual for it, I see that…

You can also communicate directly to DX controllers by connecting the PC’s RS-232 port to the DX controller’s RS-232 port with a null modem cable. (DX is the only controller with a built-in RS-232 port. In this case, do not use the converter. Only one …

Dec 26, 2014 · I believe the VT100 has a DB25 serial port so you'll need a DB9-DB25 adapter as well as the USB adapter. Instead of an adapter you can pick up a "null modem" cable that is DB5 on one end and DB9 on the other. Here's the instruction manual for …