Hi, I'm Bill. I'm a software developer with a passion for making and electronics. I do a lot of things and here is where I ...

Hi, I'm Bill. I'm a software developer with a passion for making and electronics. I do a lot of things and here is where I ...

There are all kinds of ways to take an LED bulb and turn it into a stunning pendant light: Pop it inside stacked thrifted ...

as you’ve got options like the 27-inch Mobile Pixels Mini-LED 2K QHD gaming monitor with a $50 discount from StackSocial. Just input the code GAMING50 upon checkout, and it will be yours for $ ...

Today, We will review the Cytron Maker Uno RP2040 development board combining the Arduino UNO form factor with the Raspberry Pi RP2040 microcontroller that makes it programmable with the Arduino IDE ...

In a previous article, we looked at connecting various kinds of Arduino hardware ... one for each colored LED, and one GND. The code is smilier to Blink, except that you turn all the lights ...

It also stores the user-made code that makes it do stuff ... You’ll just have to turn on the built-in LED for 0.5 seconds, then turn it off for another 0.5 seconds. Open your Arduino IDE. You should ...

In this case, our Blink code should make the Arduino say “One cycle of on and off LED” on the serial monitor after each blink cycle. Like any other extension, you just have to go to the Extensions tab ...

What is the Arduino IDE? As we know ... When we connect an LED to this pin, the LED will blink. The rate of blinking can be changed by changing the delay, by changing the values in the delay() ...