This project is inspired by Peter Balch Oscilloscope in a Matchbox project. We have changed a few codes and hardware to suit our requirements. Materials Required to build an Arduino based Oscilloscope ...

Voltage ranges were adjusted from 3.3V to 5V. Sampling was off for Arduino nano, this board is capable of sampling frequency 65 kHz! 3 buttons were added. Two for setting the sampling (increase and ...

Oscilloscopes are used to observe the change of an electrical signal over time, such that voltage and time describe a shape which is continuously graphed against a calibrated scale. Due to the size, ...

Today I will be demonstrating how to use the Arduino and a software, which will be developed with Python, to build a low cost, 4-channel Arduino oscilloscope capable of performing the tasks for which ...

ArdOsc is an awesome Arduino oscilloscope project built using an Arduino Nano and a tiny 1.3” OLED display. Created by maker Peter Balch the Arduino oscilloscope can display data on a computer ...

Got an Arduino board laying around? Make your own oscilloscope in only four steps. It might be the geekiest DIY project ever.

There’s little question that an oscilloscope is pretty much a must-have piece of equipment for the electronics hacker. It’s a critical piece of gear for reverse engineering devices and … ...

The code the arduino runs is based on software version 2.0. You will need an arduino nano with an Atmel ATMega 328p for this (Note: a 168p does not have enough memory for the program).

Oscilloscopes are used to observe the change of an electrical signal over time, such that voltage and time describe a shape which is continuously graphed against a calibrated scale. Due to the size, ...