The tilt sensor module can be connected to arduino using suitable jumper wires. First of all connect the power supply lines; VCC and GND of the module to 5V and GND of the Arduino respectively. Next ...

4. Connect the breadboard rails to Arduino GND and +5V, and then check that your setup matches that of Figure 10-3. For this project, I’ve attached the servos to a pan-and-tilt housing module ...

This project uses a Raspberry Pi 2 or 3, an Arduino Uno, some servos, and a USB webcam. The end result is a camera mounted to the servo that’s controlled by the Arduino. Everything else is ...

Researchers at Yokohama National University have created a liquid-based tilt sensor that only needs simple interface electronics – some 10MΩ resistors and a Microchip ATmega microcontroller in the ...