The Arduino will then work to pick up on button presses, and relay that information to the correct section of the flamethrower. To play, just switch on Guitar Hero and start strumming and pressing ...

Meanwhile, the reset button is just that — to ... With the hardware front covered, let's start discussing the software perspective. For your Arduino to work as you intended, you'd need to ...

It's free to download, and you don't even need an Arduino board on standby to install it. Click the Start button in the bottom-right of the page. Click the Download button. Let the download run ...

An Arduino Nano controls two relays which in turn can turn the car on, start it, and turn it off. Instead of adding a button for “push to start” he opted for a 13.56MHz RFID module.

Here, we’ll show you how to get a start-to-finish Arduino primer with a killer project ... of-concept light that turns on when you press a button. It’s friggin’ cool: Chances are, if ...

Here's a project for Arduino fans with an old iPhone sitting in their junk drawer. Following these instructions from Will O'Brien, you can craft a remote start system that's triggered by SMS.

You can read the state of a button using Arduino and a few lines of code. The actual state is shown in the Serial Monitor window as 0 or 1, 0 meaning the button is not pressed and 1 that the button is ...