When the button is pressed the Arduino board will put pin 2 in HIGH state, meaning 5V on pin 2. This voltage is used to drive the transistor that will switch ON the relay and the load (in our case the ...

If so, remember to connect the VCC pin to 5V of the Arduino board to enable the control input pins IN1 and IN2. Also note at this point that, if you want perfect galvanic-isolation, do not link ...

It is equipped with 32 Inputs (16 x digital 4-30V, 8 x analog 0-10V, 4 x analog 0-5V, 4 x analog 4-20mA) and 20 Outputs (8 x relay 250V/5A, 2 x open-collector 30V/1A, 8 x analog 0-10V) and offers ...