TSL25911 Sensor Module Pinout. The TSL25911 sensor module has a total of 5 pins. Two power pins, one interrupt pin, and two I2C pins. The pinout of the module is as follows: VCC - Provides power for ...

Light sensor Dark sensor. Light and dark detection using an LDR. For this project, let’s stick to the LDR sensor module so we can select the light or dark detection by placing jumpers. We’ll be using ...

It should be a piece of cake if you program your Attiny85 chip (not Digispark) using your existing Arduino IDE with the help of one “USB tiny ISP (v2.0)” programmer. The software/Arduino sketch /* * ...

This package contains an Arduino library for digital light sensor breakout boards containing the BH1750FVI IC. The BH1750 board uses I2C for communication which requires two pins to communicate with ...

This project uses an Arduino board with a photoresistor sensor and a GSM shield to send an SMS message when the light level detected by the sensor falls below a certain threshold. Connect the GSM ...

After uploading the code the Piezo will start making short beeps. On bright light the Piezo will only beep and on dark light it will be short. Some ideas for this experiment: Alarm for Lights in the ...

In this arduino based color detector project, we are going to interface TCS320 color sensor with Arduino UNO. ... With no filter mode the sensor detects white light. Components Required. Hardware: ...

The other end of the wires had female header pins that securely connected to the sensor. The potentiometers on the PIR sensor can be adjusted to control sensitivity and output. In the code, the lights ...

He’s not accounting for the rise time of the Nd solid state laser, which is going to dominate his measurement here. I think if I were trying to do this with an AVR, I’d hook my light detector ...