The ATmega328 microcontroller chip which is used on the Arduino Nano/Uno boards has an internal EEPROM storage of 1024 bytes. The ATmega2560 microcontroller chip of the Arduino Mega has 4096 bytes of ...

Arduino & External EEPROM. Now we have the key hardware handy. Now we can begin an experiment by connecting it with an Arduino board to write to and read from the EEPROM chip. We can write anything we ...

EEPROM - Arduino based EEPROM programmer This is a very simple and very slow EEPROM programmer using an Arduino Nano based on the design from Ben Eater for his 8-bit computer project . The original ...

Since the ST24C04 512-byte device in question has an I 2 C bus it’s a straightforward add-on for an Arduino Mega, so we’re shown the wiring for which only a couple of pull-down resistors are ...

20 thoughts on “ Destroying An Arduino’s EEPROM ” wardy says: May 16, 2011 at 4:33 am Presumably it then went insane and locked him in an airlock? Report comment. Reply.

Here, a common cathode 7-segment LED display is connected to Arduino for displaying the digits. The code (Arduino sketch) allows push button increment of the counter from 0 to 9. The whole circuit can ...

Meet the Arduino Compatible RFID Reader Module. It can hold card data for up to five cards, takes seconds to program, and holds card data in EEPROM memory, which means that the cards are saved ...