Set receiver board in RX mode without decoding by making SJ1 and SJ2 low. Connect pin 3 of ATmega8A of transmitter board to pin 2 of ATmega8A of receiver board. Connect ground lines of both boards.

Once you have built both the circuits on the breadboard, power them individually and connect the Audio source to the Transmitter part, now place the receiver circuit in line with the transmitter ...

In this study, wireless transmitter and receiver including high gain amplifiers have been implemented in CMOS circuits for the first time for spin-torque nano-oscillator based wireless communication.

The calculated RX and TX eye diagrams are evaluated by using the D-PHY protocol to identify the quality of the signals. An in-house MIPI tool is built to directly display the calculated eye diagrams ...

The MT8860A weighs in as the first single test instrument capable of conducting both transmitter and receiver measurements as per the IEEE 802.11 standard at speeds up to ten times faster than ...