Normally, a DC jack/socket is provided on the Arduino board for external power adaptor, as shown in Fig. 1. Our project is to make a 9V battery adaptor plug to be used at DC jack/socket on the Arduino ...

How to Power Arduino boards with a 3.7V lithium battery? You might have thought that since most electronics nowadays run-on Li-ion or Li-po batteries, can we also power an Arduino with a 3.7V Li-Ion ...

Charging voltage is controlled by two BC547 transistors (T1 and T2), whose bases are connected to Arduino board pins 8 and 9. To know the status of the battery when 230V AC mains power is off, press ...

Board Supply: 7V to 9V(Max) Battery Input: 0-5V(max) – no reverse polarity Constant Current Load: 37mA to 540mA(max) – 16 Steps – can be modified by the user Circuit Analysis. Figure 1 shows the ...

For this project, its creator used an Arduino Pro mini, a cellphone battery, a few other tech parts, and an old digital watch that was big enough to hold the PCB board. The result may not be the ...

Johan Kanflo has been using Arduino compatible boards based on Tiny328 MCU with an ISM radio module (wireless Arduino clone), but he found that finding a case was not easy, and was quite not ready to ...

Arduino Nano Runs Battery Spot Welder. 23 Comments . by: Dan Maloney. March 22, 2016. Title: ... and each leg gets soldered to the MOSFET board. Welding tips are simply solid copper wire, ...

Souliss runs on most of the Arduino compatible boards (a complete list of compatible boards is avialable in the wiki and in the relevant hardware section). Some special design has been shared publicly ...

This week, Intel and Arduino are releasing their first product pushed directly on the education market, the Arduino/Genuino 101 board powered by the Intel Curie module. The Intel Curie Module The A… ...

Introduction: Keyestudio UNO R3 development board is a microcontroller board based on the ATmega328P (), fully compatible with ARDUINO UNO REV3.It has 14 digital input/output pins (of which 6 can be ...