This shield could be a good alternative to hobby RC controllers for robots that need a customizable open-source motor controller. The PCB design and source code are available on GitHub .

In this DIY session, we make an Arduino Motor Driver Shield to drive DC motors, stepper motor and Servo Motor.Compatible with Arduino UNO and Arduino Mega, this motor driver shield can operate 4 DC ...

This is a library for the Arduino that interfaces with the Arduino Motor Driver Shield R3. It makes it simple to drive two brushed, DC motors. Download the archive from GitHub, decompress it, and move ...

•A four-wheel drive vehicle was made using Arduino Uno R3 and a motor shield over it. An ultrasonic sensor was used to detect obstacles and a program was made to move away when and obstacle is ...

The DC motor portion of the project is based on the Infineon brushed DC motor controller TLE94112EL Arduino Shield. In this installment we will focus on the Arduino sketch software to control all the ...

It uses an Arduino and a motor shield for locomotion, with commands pushed to it via USB. This setup makes programming very easy. Here [Andrej] has a keyboard and HDMI monitor plugged in to do a ...

Infineon DC Motor Control Shield for Arduino enables fast and inexpensive prototyping of dc motor control. Device is capable to drive two uni-directional dc motors (half bridge configuration) or one ...

The A000079, Arduino Motor Shield is based on the L298, which is a dual full-bridge driver designed to drive inductive loads such as relays, solenoids, DC and stepping motors. It lets you drive two DC ...

The Shield will be a typical Arduino UNO shield with all pins of Arduino UNO can be used along with extra pins for 3.3V, 5V, 12V and GND. Here the PCB is designed on the EasyEDA PCB Designer and ...