The arduino nano sends the waveform type and frequency via SPI to the AD9833, that generates the requested waveform. While doing this, the OLED display (SSD1306) is updated by the arduino via I2C, ...

Quick, how do you wire up an SPI bus between a microcontroller and a peripheral? SCK goes to SCK, MISO goes to MISO, and MOSI goes to MOSI, right? Yeah. You’ll need to throw in a chip select … ...

Using SPI Protocol in Arduino. Before start programming for SPI communication between two Arduinos.We need to learn about the Arduino SPI library used in Arduino IDE.. The library <SPI.h> is included ...

Arduino_SPI_bridge is a small Arduino project to configure an Arduino as USB<->SPI gateway. The main objective for this project was to provide a OS-independent SPI-gateway for the stm8gal application.

It intercepts the SPI calls from the Arduino to an SRAM chip, and translates the address information to find the appropriate data on a collection of 23K256 devices.

Circuit to Interface N76E003 with Arduino via SPI. As we can see in the schematic, the Arduino Nano is connected with the SPI of N76E003. On the extreme left, the programming interface connection is ...

2) Display information to LCDs controlled by your Arduino. 3) Be programmed to act as an extensive combination lock 4) Offer commands, such as ENTER, LOAD, CLEAR, etc.

This research aims to create an arbitrary waveform generated by simulation to be observed using an oscilloscope. This waveform generator is explicitly intended to support signal processing learning.