The code is an Arduino project for the Digispark Attiny85 to turn on a light source when the PIR sensor detects something. Note that after powering the PIR sensor module, it needs about 10 to 60 ...

Hi, I'm Bill. I'm a software developer with a passion for making and electronics. I do a lot of things and here is where I ...

In the microcontroller era today, Arduino ... light level is below a threshold value. Here an LDR (Light Dependent Resistor) is used to measure the light level. The alarm system is triggered when a ...

Get close enough to this raven and you’ll set off the PIR sensor ... thunder. The light comes from a whopping 10-watt, 12-volt power LED. This bird’s brain is an Arduino Nano, which is ...

Arduino leak sensors only have three ... from intruder detection to home automation. PIR motion sensors use infrared light to detect movement. Light is emitted and the sensor will trigger if ...

You’ll see PIRPin defined as “2” and OutPin defined as “3”—these correspond to where you plugged the PIR sensor and power relay into the Arduino ... even plug a light or another ...

Most ambient lights and sensors are designed to generate light to even out the picture on the front of the panel and reduce any light bleed from the back of an LCD display. This Arduino-powered ...

Use Arduino to handle sensor input and relay control. Pi runs a Python Flask server with a simple UI to toggle GPIO pins via serial commands sent to the Arduino. Use cron jobs on Linux to schedule ...

Wireless sensor networks are nothing new to Hackaday, but [Felix]’s wireless PIR sensor node is something ... a very tiny Arduino compatible board with solder pads for an RFM12B and RFM69 ...