So if you are in a plan to make your own open source microcontroller platform – Arduino, no doubt, you need an AVR chip with pre-charged bootloader! Atmega328-PU/ Atmega328P-PU – 1 16Mhz Xstal – 1 ...

Plug the RFID module into the breadboard with enough space around it. Connect the VCC pin to the Arduino's 3.3V (not 5V), and GND to the ground rail. For the data connections, wire SDA to Pin 10, SCK ...

If you are interested in learning more about the history of the iconic Arduino UNO microcontroller you are sure to be interested in the new article published this month to the official Arduino ...

Powered by the ATMega328p microcontroller and utilizing a 3D ... The first version of the DIY Arduino soldering iron garnered quite a bit of attention, so it seems there’s a decent number ...

Then, an Arduino board might be exactly what ... For the Rev3, the microcontroller is an ATmega328P. It's an 8-bit AVR microcontroller running at a clock speed of 16 MHz and boasts a flash memory ...

The binary watch is powered by an Atmel/Microchip ATmega328P programmed using the Arduino platform. For more information on the wearable project check out the video embedded below or jump over to ...

A typical Arduino microcontroller board is pretty small, about the size of a credit card. This makes it suitable for embedding into all sorts of electronic devices. But it's possible to go even ...