The code compiles on Arduino IDE 1.8.x or higher with board set to Arduino Uno. The transmitter code is in mtx (master mcu) and stx (slave mcu) folders. The receiver mcu code is in the rx folder. No ...

In that case, [Electronoobs] has an Arduino powered RC transmitter with your name on it. But this is no scrap of protoboard with a couple of cheap joysticks on it, though he has made one of those too.

This cable is used by the RC transmitter to connect the radio transmitter to the reciever. Once this is done, a small connector has to be made using headers, perfboard and shrinkwrap. This connector ...

3 thoughts on “ Arduino RC Transmitter For Homebrew Projects ” Daren Schwenke says: January 15, 2019 at 1:26 pm Perfect timing.. I just ...

3D print and build an Arduino Pistol-grip Transmitter for controlling Remote Control cars. Today, we’re assembling and wiring a 3D printed Arduino-based pistol-grip radio transmitter that operates ...

This project mixes the commands sent from the Arduino to the transmitter with the manual input by connecting an Arduino to a Radio Control Transmitter. A trainer cable for the RC transmitter had to be ...

Long-range RC transmitter “I started using Bluetooth devices like the HC-05 modules, but I found that these sometimes randomly disconnected. Since then I’ve been using the NRF24L01 modules ...

LoRa is a wireless Radio frequency technology introduced by a company called Semtech intended to be used to transmit bi-directional information to a long-distance without consuming much power.If you ...

The code compiles on Arduino IDE 1.8.x or higher with board set to Arduino Uno. The transmitter code is in mtx (master mcu) and stx (slave mcu) folders. The receiver mcu code is in the rx folder. No ...

3D print and build an Arduino Pistol-grip Transmitter for controlling Remote Control cars. Today, we’re assembling and wiring a 3D printed Arduino-based pistol-grip radio transmitter that operates ...