News
[Fran’s] been working on her own version of the Arduino. She calls it CuteUino for obvious reasons. The size of the thing is pretty remarkable, fitting within the outline of an SD card. But that ...
Attach the LED strip to the Arduino: Look at the labels closest to the wires to determine the correct pins. +5v and GND should go into the according Pin on the Arduino and the remaining wire ...
That’s stupid! Why use a bunch of parts when you can use an Arduino? However, we rarely see those two comments on the same post. Until now. [ZHut] managed to bring these two worlds together by ...
In this project we are going to design an 8x8 LED matrix display, for that we are going to interface an 8x8 LED matrix module with Arduino Uno. An 8x8 LED matrix contains 64 LEDs which are arranged in ...
3D-Printed-Arduino-Caller-Project An Arduino-based caller with 3D printed parts and LED digits. Project Overview This project involves creating a call panel for a system with 10 positions (spots), ...
You can control the brightness of these LEDs using variable resistors VR1, VR2 and VR3 respectively. Parts Needed Arduino UNO board – 1 5mm LEDs Red, Green, Blue – each 1 100K Variable resistor – 3 1K ...
In this project we are going to interface a ROTARY ENCODER with ARDUINO. ARDUINO UNO is an ATMEGA controller based development board designed for electronic engineers and hobbyists. In ARDUINO we have ...
Step 2: Connect LED Light Strips to the Arduino Now that you have all the necessary parts, it’s time to connect the LED light strips to the Arduino. The first step is to identify positive (+) and ...
The circuit is driven by a MAX7219 IC that is being controlled through an Arduino microcontroller board, to create an 8X8 LED matrix. The connection of the LED matrix and the IC was done on a ...
Results that may be inaccessible to you are currently showing.
Hide inaccessible results