Plug the RFID module into the breadboard with enough space around it. Connect the VCC pin to the Arduino's 3.3V (not 5V), and ...

Aerial drone footage shows the humpback whale (Megaptera novaeangliae) missing its iconic lobed fluke, which is responsible ...

LILYGO T-Embed SI4732 is an ESP32-S3 development board with an AM/FM radio, a TFT display, a rotary encoder, a built-in ...

RA2L2 low-power MCUs are the industry’s first MCU to support USB-C Revision 2.4 with 15W CC detection, USB FS, CAN, I3C, and low-power UART.

(Hint: there’s no Arduino-provided code involved; hardware registers and the __asm keyword show up.) If you learned embedded programming in an earlier era, this will probably seem glaringly obvious.

Why, you ask? Why not, Lian Li replies. We give you Lian Li Hydroshift II LCD Curve. It's still in prototype form and won't be available until later this year, and not before October, so the ...

Linux: the ultimate Windows 10 upgrade? The bad news: Windows 10 is definitely going end of life this year. The good news: these Linux distros are ready and waiting to take advantage. APC tells ...

Using default boot mode with no changes to hardware configuration. Different USB cables and ports Holding BOOT and RESET in different sequences Sketches known to work on other ESP32-S3 boards ...

Create a new folder called "LiquidCrystal_I2C" under the folder named "libraries" in your Arduino sketchbook folder. Create the folder "libraries" in case it does not exist yet. Place all the files in ...