Simple Arduino Nano, L298N stepper driver, force pressure sensor, end stop test code. This schematic and code consists gripper with grip pressure sensing and on start calibration via end stop.

As you know, any L298N module has the ability to drive two motors at once, but you may not know that one instance of the library is intended to pilot only one motor. So if you need to drive two motors ...

Spread the loveSchematic drawing software for Arduino, Raspberry Pi, and other Single Board Computers (SBCs) is essential to developing electronics projects. When it comes to creating circuits on a ...

Next, we will connect the L298N Dual H-Bridge Motor Controller to an Arduino. Once that’s done we’ll run a motor demo sketch to put the device through its paces. After the demo, we will expand upon ...