[Blue Blade Fish] wanted to build an Arduino-based aquarium controller. He’s detailed the system in (so far) 14 videos and it looks solid. This isn’t just a simple controller, either.

3 thoughts on “ An Arduino Controller For Hot Air Handles ” Brian says: September 4, 2020 at 8:51 am Uh, you might wanna put a fuse or two in there, somewhere. Report ...

An Arduino (so far it has only been tested with the Arduino Uno R3, feel free to give me feedback about other models). A NES controller that you are ready to sacrifice to this cause. At the very top ...

The block control project now incorporates “all” solid-state components controlled by an Arduino microcontroller. I refer to this updated article as “CTC Signals 2.0.” The scope of the project ...

The provided Arduino library is called ROSArduinoBridge and is located in the ros_arduino_firmware package. This sketch is specific to the hardware requirements above but it can also be used with ...

Here is a tested Arduino project that uses 3 sensor probes as water level indicator with 3 leds and one LCD display + a simple controller that turns on a motor when the water has reached the desired ...

You can control the brightness of these LEDs using variable resistors VR1, VR2 and VR3 respectively. Parts Needed. Arduino UNO board – 1 ; 5mm LEDs Red, Green, Blue – each 1 ; 100K Variable resistor – ...

The Arduino Opta micro programmable logic controller (PLC) provides a unique entry point into the automation field. Automation fields like smart homes, process controls, and robotics are project areas ...

Arduino Code for PID Enabled Encoder Motor Controller. The complete code used in this project can be found at the bottom of this page. After adding the required header files and source files, you ...