using a simple voltage divider circuit comprising resistors R1 (100K) and R2 (10K). With the values used in the voltage divider it is possible to feed voltage from 0V to 55V into the Arduino board.

One might typically use a voltage divider to knock them down to the 5 volt range of the Arduino’s 10-bit A/Ds ... [Technoyaki] decides to build an analog circuit out of sixteen resistors ...

The complete HS200 circuit is shown in Figure 3. The HS200 DC-DC MuxCapacitor IC is an easy-to-use, high-efficiency DC voltage divider. By combining three charge-pump voltage dividers to reduce ...

with the introduction of three families of thick-film precision resistive dividers targeting high-voltage measurement circuits. TT Electronics is further extending its range of solutions for ...

The bulk of the circuit is creating the ... The converter goes through a voltage divider so the maximum 24 volts won’t overload the Arduino. Grabbing the data into a spreadsheet allowed some ...