[Miroslav]’s project generates square waves up to 2.22 MHz and pulses with a variable duty cycle from 1-49% and 51-99%. Output is either 5 Volt TTL levels or an adjustable 0-3.38 level.

When construction is completed and you are ready to put the function generator into operation, make sure that the polarity of power supply. Then feed 9-12V DC (9V typical) through the DC input jack.

This circuit generate sine wave oscillation, but actually we can modify the circuit to generate triangle or square wave function. This waveform generator integrated circuit chip is very interesting ...

AD9835 Based Sine/Square Wave Function Generator. Posted Thursday, January 26, 2012 shares. A Microchip PIC16F628 is used as the controller chip for this low cost and simple Since/Square wave ...

In this project, the Arduino Uno is configured as a square wave generator with user-selectable control of the frequency and duty cycle. The operating range of the system is up to 10kHz. The desired ...

What is a Function Generator? A function generator is an electronic test device or software that creates various electrical waveforms across a broad frequency spectrum. Commonly generated waveforms ...

GUI-based software tool that allows users to configure and generate square wave signals using LaunchPad TM4C123 Tiva C Series ...

Thats where this function generator sent to us by [Mohonri]comes in. Based around a ATTiny25 and a rail to rail op amp which is able to replicate frequencies from 1Hz to about 40KHz, in square ...

The simplified block circuit shows IC1 operating as a square-wave generator ... such as an operating supply range from 4 to 12 V or 5 to 18 V. Typical and maximum output power is a function ...

The answer will further depend on a statistical distribution and how one suitably specifies the square-wave performance of a function generator. When a function generator is selected by its specified ...