We wrote earlier in the week about the image sensing capability of the Arduino-friendly Pixy, and now here comes a robot... It runs on two wheels and has two (Atmel ATmega32u4) processors, one on each ...

[Dave] wanted to make an Arduino robot out of a remote-control 1950 Mercury ... and decided to give the program information from the wheels with a reed switch and a rare earth magnet.

Getting a robot to stand on two wheels without tipping over involves ... how to make one with just a few common components, an Arduino, and a bit of patience fine-tuning the PID controller.

Two screw holes is to be drilled into the Lego wheel axle to permit it ... is connected to a 5-volt pin from the Arduino.” The Arduino based Snake Robot controlled via the companion Android ...

Any oblique force causes the wheel to move sideways ... 48 stepping motors an SG90 servo connected to the Arduino development board. The robot was built for less than $100 with the most expensive ...

Imagine a robot that can transform between "flying drone" and "wheeled rover" configurations. It could potentially be quite ...

It can also be daunting to get started. Here, we’ll show you how to get a start-to-finish Arduino primer with a killer project: building a sweet robot arm. Learning any new skill is always a ...

Arduino's array of inputs and outputs proves crucial in projects from building robots to 3D printers, said Jason Kridner, co-creator of the BeagleBone line of products that combine Raspberry Pi ...