An Arduino Shield lets you to employ your Arduino for more than one project and to change the hardware setup easily. This little post is about a common (and cheap) Arduino Joystick Shield – the ...

4. Connect the breadboard rails to Arduino GND and +5V, and then check that your setup matches that of Figure 10-3. Mounting the Laser. For this project, I’ve attached the servos to a pan-and ...

This article presents a procedure for reading the analog ports of the Arduino UNO R3 board, on which an analog Joystick was connected. The analog data are related to the position of command and can be ...

This Arduino-based Pomodoro timer project also uses this 25-minute cycle. Once you push the button to start the timer, it will run for 25 minutes, display a count-up timer and a "Study time ...

Arduino’s brand-new Esplora microcontroller, packed with prebuilt sensors and features, could indicate a move for the DIY electronics company toward a wider segment of the microcontroller market ...

i usually use 3.3v atmega32u4 micros for control mods, usually in the form of knockoff pro micros. the arduino ide has had pluggable usb support for some time. its not hard to roll a library with ...

The Arduino board he went with is an Ardweeny which is no bigger than the ATmega328 footprint so it can be easily mounted off to one side. The joystick internals have been replaced with the analog ...

Even though games like Infinity Blade can be great fun on the iPhone, there's no getting around the fact that touchscreen-centric, buttonless devices don't offer the best gaming ergonomics. A ...

Arduino has announced the new UNO R4 board family for prototyping and learning. The new models feature a faster microcontroller, a USB-C connector, improved power, Wi-Fi and Bluetooth LE, and more.

If you've turned your media center into a video game console but the new school controllers just don't invoke the same feeling of nostalgia, you can easily turn an old NES controller into a USB ...