USB dummy load configuration . However, this Arduino DVM can also be used as a standalone 5-V DVM by slightly changing the hardware setup and powering the Arduino from an external power source like ...

To use it as such, you need a USB cable and a 5V power source. In the case of the Arduino Nano, a mini-B USB cable is required. The power source, on the other hand, can be a powerbank, a phone ...

[Aleksejs’s] design is based on the FE1.1s 4-port USB 2.0 hub controller, with two additional ports for charging. Each port features an LT6106 current sensor and a power MOSFET to individually ...

USB-C Power Delivery 3.0 (PD3.0) introduces a new Programmable Power Supply (PPS) mode, which allows a device to negotiate any supply of 3.3-21 V in 20 mV steps, and up to 5 A of current in 50 mA s… ...

Since Linear Tech is also a power supply chip company, they beefed up the power supply on the board, using a switching regulator to replace the linear regulator on the Arduino. This means you can get ...

Power Supply (5-12V) and External Battery connector The UDOO has been in development for more than a year, and the team says it is "80 percent ready" to deliver the final product.

Arduino explains a little more : “the Arduino USB Host Shield is based on the MAX3421E, which is a USB peripheral/host controller containing the digital logic and analog circuitry necessary to ...

Meanwhile, the Arduino Mega is getting the same USB chip along with an ATMega2560 processor with twice the memory. Right now only 128K is available, but that's a software limitation and they're ...

The Arduino cable tester is equipped with a touchscreen the Cable Tracer builds on a previous project that is now 70% ... Approx 70% smaller footprint, additionally includes RJ45, USB-A3, ...