It runs on an Arduino MEGA 2560 PRO (or similar microcontroller) and supports a wide array of additional hardware including pressure transducer, water level sensor, flow meter, OLED display, and more.

Tarts Sensors allow both developers and hobbyists the ability to develop wireless sensor networks with Arduino, Raspberry Pi and BeagleBone. Contacts Tarts Sensors Matt Moulton, 801-255-9910 press ...

Hi, I'm Bill. I'm a software developer with a passion for making and electronics. I do a lot of things and here is where I ...

If you’re going to develop another Arduino-compatible board these days, you might as well take a “kitchen sink” approach. The Smart Citizen Kit piles it on, including Wi-Fi, an SD… ...

The additional sensors include a nine-axis Inertial Measurement Unit, as well as temperature, pressure, humidity, light, color, and gestures sensors. Arduino also announced a new Arduino SIM for ...

Aiming at sensor fusion application development, Rutronik has created a single Arduino-compatible board with a plethora of sensors from Infineon, Bosch SE and Sensirion. Called ‘RAB1 – Sensorfusion’, ...

Additionally, they could be used to bring an additional visual layer to dance performances, as demonstrated in the video below.

Arduino uses the following categorisation for libraries — Communication, Data Processing, Data Storage, Device Control, Display, Other, Sensors, Signal Input/Output, and Timing — with ...

Next we connected the water flow sensor’s output to the Arduino board (filled with the sketch) and allowed water flow through the water flow sensor at a steady rate of about 1 Litre/minute. Besides ...

That’s right, these parking sensors are powered by an Arduino board, and the only extra components that were used in the project are a HC SR04 ultrasonic sensor, an active buzzer, and jumper wires.

This articles describes how you can use I2C (TWI) communication, Arduino and temperature sensors to measure 3 different temperatures. It can be very helpful when you want to measure the outside, ...